循环流化床固硫灰复合胶凝材料的早期水化特点.pdf

中图分类号,循环流化床固硫灰,放热峰,水泥,水泥强度,水泥水化,流化床,粉煤灰,学术文献
文档页数:4
文档大小:291.95KB
文档格式:pdf
文档分类:学术文献
上传会员:
上传日期:
最后更新:

粉煤灰综合利用 FLY ASH COMPREHENSIVE UTILIZATION 2010NO.1 循环流化床固硫灰复合胶凝材料的早期水化特点* Early-age Hydration Heat of Complex Binder Prepared with Circulating Fluidized Bed Desulfurized Fly Ash 张磊,杨久俊,王雪平 (天津城市建设学院材料工程系,天津300384) 摘要:研究了大掺量循环流化床固硫灰复合胶凝材料的物理力学性能,以及其早期水化放热特点和水化产物.研 究结果表明:利用接量为30%~60%固硫灰制备的复合胶凝材料满足32.5、42.5强度等级水泥标准;固硫灰复合胶凝 材料的标准稠度比水泥的标准稠度大,且随着固硫灰用量的增加标准稠度增加,同时凝结时间变长;与P.042.5水泥相 比,循环流化床固硫灰复合胶凝材料水化的诱导期较长,水化放热速率明显变小,水化热较低. 关键词:循环流化床固硫灰;复合胶凝材料;早期水化热 中图分类号:TU528.041;X773文献标识码:A 文章编号:1005-8249(2010)01-0009-04 Department of Materials Engineering Tianjin Institute of Urban Construction Tianjin 300384 China) Abstract:The influences of desulfuriaed fly ash on the strength setting time water requirement for nommal consistency and hydration heat and products of plex binders were investigated.The results showed that plex binders with 305%-60%desulfurized fly ash content can ply with the standard of 32.5 or 42.5 cement.The water requirement for nomal consistency of plex binders increased from 4%to 6%(ab- solute increment value)with an addition of 30%to 60%desulfurized fly ash.The setting time deeressed with an increase of desulfurized fly ash content.The hydmtion heat of plex binder has a longer induetion period paring with P.042.5 cement and the hydrntion heat reection ratio is lower. Key words cireulating fluidized bed deaulfurized fly ash:plex binder:early-age hydration heat 水化、硬化特点的研究甚少,尤其是其早期水化特点还 循环流化床锅炉(Cireulating Fluidized Bed 很少有研究涉及.本文利用循环流化床固硫灰进行了 CFB)燃煤技术,因可...

资源链接请先登录(扫码可直接登录、免注册)
①本文档内容版权归属内容提供方。如果您对本资料有版权申诉,请及时联系我方进行处理(联系方式详见页脚)。
②由于网络或浏览器兼容性等问题导致下载失败,请加客服微信处理(详见下载弹窗提示),感谢理解。
③本资料由其他用户上传,本站不保证质量、数量等令人满意,若存在资料虚假不完整,请及时联系客服投诉处理。

投稿会员:匿名用户
我的头像

您必须才能评论!

手机扫码、免注册、直接登录

 注意:QQ登录支持手机端浏览器一键登录及扫码登录
微信仅支持手机扫码一键登录

账号密码登录(仅适用于原老用户)