某工程整体抬升后加固方案优化研究.pdf

学术文献
文档页数:4
文档大小:2.03MB
文档格式:pdf
文档分类:学术文献
上传会员:
上传日期:
最后更新:

2015年8月下 施工技术 第44卷第16期 CONSTRUCTION TECHNOLOCY 31 DOI:10. 7672/sgjs2015160031 某工程整体抬升后加固方案优化研究 李今保,邱洪兴²,赵启明',章佳娟²,李小凡² (1.江苏东南特种技术工程有限公司,江苏南京210008;2.东南大学土木工程学院,江苏南京210096) 【摘要】本建筑为地下1层、地上局部8层框架结构的沿街商铺,因1层结构的原设计高度为3.50m,不能满足使用 要求,根据业主要求,将该建筑1层层高由3.5m拾升至4.8m。

结构1层柱抬升后,1层柱的计算高度发生变化,结 构的刚度、周期、位移以及结构的配筋等均发生了较大变化,导致计算结果不能满足设计规范要求。

采用增大截面 法进行加固设计后,计算结果可满足设计规范要求,但该加固设计方案存在加固工程量大、加固成本高等缺点。

因 此对加固方案进行优化设计,采用增设短肢剪力墙的优化方案即可满足现行设计规范要求,从加固效果、加固工程 量和加固造价等各方面都得到很好的效果,从而证明加固设计方案必须要进行优化的重要性。

[关键词]加固;建筑物抬升;结构刚度;方案优化 [中图分类号]TU746.3 [文献标识码]A [文章编号〕1002-8498(2015)16-0031-04 OptimizationResearchofStrengtheningSchemeofOverall UpliftofSomeEngineering Li Jinbao',Qiu Hongxing²Zhao Qiming',ZhangJiajuan²,Li Xiaofan² (1.Jiangsu Southeast Special Technical Engineering Co.Lad.,Nanjing,Jiangsu 210008,China; 2.School of Civil Engineering,Southeast Unitersity,Nanjing,Jiangsu 210096,China) Abstract:This building is a frame structure with 8 floors and 1 underground floor, according to the requirement of the owner, the ground floor needs to be lifted from the height of 3.5m to the height of 4.8m.After the overall uplift, the column’ s calculation height is changed, the stiffness, the natural vibration period,the displacement,and the reinforcement are also changed,so the calculation results could not satisfy the requirements of the standard.If the cross sections of the members are increased,the problems can be solved, but the cost of the construction will be too high.According to the parative study,the strengthening design of adding the short-leg shear wallis proposed,the calculation results can satisfy the requirements of the standard.The reinforcement effect is very good and the strengthening cost is reduced. It shows that the optimization research of strengthening scheme is very important. Key words:strengthening;structure uplift;stiffness;scheme optimization 目前我国加固改造工程规模正在逐年增加,由计计算发现结构的刚度、周期、位移以及配筋等均 于加固设计方案的确定直接影响加固工程的构件发生了不同程度的变化。

首层柱的层间位移角和 加固量、造价、使用面积等众多因素,因此加固改造配筋等均不能满足国家现行设计规范的要求,需要 设...

资源链接请先登录(扫码可直接登录、免注册)
①本文档内容版权归属内容提供方。如果您对本资料有版权申诉,请及时联系我方进行处理(联系方式详见页脚)。
②由于网络或浏览器兼容性等问题导致下载失败,请加客服微信处理(详见下载弹窗提示),感谢理解。
③本资料由其他用户上传,本站不保证质量、数量等令人满意,若存在资料虚假不完整,请及时联系客服投诉处理。

投稿会员:匿名用户
我的头像

您必须才能评论!

手机扫码、免注册、直接登录

 注意:QQ登录支持手机端浏览器一键登录及扫码登录
微信仅支持手机扫码一键登录

账号密码登录(仅适用于原老用户)