Standard Method of Test for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test) AASHTO Designation:T 240-211 Technically Revised:2021 Editorially Revised:2021 Technical Submittee:2b Liquid Asphalt ASTM Designation:D2872-04 AASHO American Association of State Highway and Transportation Officials 555 12th Street NW Suite 1000 Washington D.C.20004 Standard Method of Test for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test) AASHTO Designation:T 240-211 AASHIO Technically Revised:2021 Editorially Revised:2021 Technical Submittee:2b Liquid Asphalt ASTM Designation:D2872-04 1. SCOPE 1.1. This test is used to measure the effect of heat and air on a moving film of asphalt binder and to provide residue for additional testing.The effects of this treatment are determined from measurements of the properties of the asphalt binder before and after the test. 1.2. The values stated in SI units are to be regarded as the standard. 1.3. This standard may involve hazardous materials operations and equipment.This standard does not purport to address all of the safety concerns associated with its use.It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4. The quality of the results produced by this standard are dependent on the petence of the personnel performing the procedure and the capability calibration and maintenance of the equipment used.Agencies that meet the criteria of R 18 are generally considered capable of petent and objective testing/sampling/inspection/etc.Users of this standard are cautioned that pliance with R 18 alone does not pletely assure reliable results.Reliable results depend on many factors;following the suggestions of R 18 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors. 2. REFERENCED DOCU...
推荐内容/By 图集吧
- ISO-4892-1PlastICS -Methods of exposure tolaboratory light sources.pdf
- ASTM-A780/A780M-09 2015 Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings.pdf
- ASTM-A780/A780M-20 Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings.pdf
- GB 151-1999 tubular heat exchangers.pdf
- NF EN 13286-52-2005 Unbound and hydraulically bound mixtures - Part 52 method for the manufacture of test specimens of hydraulically bound mixtures using vibrocompression.pdf
- NF EN 13108-2-2006 Bituminous mixtures - Material specifications - Part 2 asphalt concrete for very thin layers - M¨¦langes bitumineux.pdf
- NF EN 12272-1-2003 Surface dressing - Test methods - Part 1 rate of spread and accuracy of spread of binders and chippings - Enduits superficiels d\'usure.pdf
- EN 12350-7 2019/AC-2022 Testing fresh concrete - Part 7 Air content - Pressure methods.pdf
- ASTM D3359-17 Standard Test Methods for Rating Adhesion by Tape Test.pdf
- ASTM B108/B108M-19 Standard Specification for Aluminum-Alloy Permanent Mold Castings.pdf
- ASTM A802-19 Standard Practice for Steel Castings, Surface Acceptance Standards, Visual Examination.pdf
- AASHTO T 89-13(2021) Standard Method of Test for Determining the Liquid Limit of Soils.pdf