ASTM A563-15 Standard Specification for Carbon and Alloy Steel Nuts.pdf

carbon,hex,国外标准
文档页数:9
文档大小:114.98KB
文档格式:pdf
文档分类:国外标准
上传会员:
上传日期:
最后更新:

Designation:A563-15 INTERNATIONAL Standard Specification for Carbon and Alloy Steel Nuts1 This standard is issued under the fixed designation A563;the number immediately following the designation indicates the year of original adoption or in the case of revision the year of last revision.A number in parentheses indicates the year of last reapproval.A superscript epsilon (e)indicates an editorial change since the last revision or reapproval. This standand has been approved for use by agencies of the U.S.Department of Defense. 1.Scope* High Temperature Service or Both 1.1 This specification2 covers chemical and mechanical A242/A242M Specification for High-Strength Low-Alloy requirements for eight grades of carbon and alloy steel nuts for Structural Steel general structural and mechanical uses on bolts studs.and A307 Specification for Carbon Steel Bolts Studs and other externally threaded parts. Threaded Rod 60 000 PSI Tensile Strength A325 Specification for Structural Bolts Steel Heat Treated NoTE I-See Appendix XI for guidance on suitable application of nut 120/105 ksi Minimum Tensile Strength grades. A354 Specification for Quenched and Tempered Alloy Steel 1.2 The requirements for any grade of nut may at the Bolts Studs and Other Externally Threaded Fasteners supplier's option and with notice to the purchaser be fulfilled A394 Specification for Steel Transmission Tower Bolts by furnishing nuts of one of the stronger grades specified Zinc-Coated and Bare herein unless such substitution is barred in the inquiry and A449 Specification for Hex Cap Screws Bolts and Studs purchase order. Steel Heat Treated 120/105/90 ksi Minimum Tensile 1.3 Grades C3 and DH3 nuts have atmospheric corrosion Strength General Use resistance and weathering characteristics parable to that of A490 Specification for Structural Bolts Alloy Steel Heat the steels covered in Specifications A242/A242M A588/ Treated 150 ksi Minimum Tensile Strength A588M and A709/A709M.The atmospheric corrosion ...

资源链接请先登录(扫码可直接登录、免注册)
①本文档内容版权归属内容提供方。如果您对本资料有版权申诉,请及时联系我方进行处理(联系方式详见页脚)。
②由于网络或浏览器兼容性等问题导致下载失败,请加客服微信处理(详见下载弹窗提示),感谢理解。
③本资料由其他用户上传,本站不保证质量、数量等令人满意,若存在资料虚假不完整,请及时联系客服投诉处理。

投稿会员:匿名用户
我的头像

您必须才能评论!

手机扫码、免注册、直接登录

 注意:QQ登录支持手机端浏览器一键登录及扫码登录
微信仅支持手机扫码一键登录

账号密码登录(仅适用于原老用户)