BRITISH STANDARD BS EN ISO 7093-1:2000 Incorporating Corrigendum No.1 Plain washers-Large series- Part 1:Product grade A The European Standard EN ISO 7093-1:2000 has the status of a British Standard ICS21.060.30 NO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAW SE BS EN ISO7093-1:2000 National foreword This British Standard is the official English language version of EN ISO 7093-1:2000.It is identical with ISO 7093-1:2000 including corrigendum February 2001. The UK participation in its preparation was entrusted to Technical Committee FME/9 Bolts nuts and accessories (QA hose clamps) to Submittee FME/9/6 General purpose fasteners and accessories which has the responsibility to: aid enquirers to understand the text; present to the responsible international/European mittee any enquiries on the interpretation or proposals for change and keep the UK interests informed; monitor related international and European developments and promulgate them in the UK. A list of organizations represented on this mittee can be obtained on request to its secretary. Cross-references Attention is drawn to the fact that CEN and CENELEC Standards normally include an annex which lists normative references to international pblications with their corresponding European publications.The British Standards which implement these international or European publications may be found in the BSI Standards Catalogue under the section entitled "International Standards Correspondence Index'" or by using the“Find"facility of the BSI Standards Electronic Catalogue. A British Standard does not purport to include all the necessary provisions of a contract.Users of British Standards are responsible for their correct application. Compliance with a British Standard does not ofitself confer immunity from legal obligations. Summary of pages This document prises a front cover an inside front cover the EN ISO title page the EN ISO foreword page the ISO page pages ii and iii a blank p...